A perimeter cable management system designed to run at ceiling height. With a range of overlapping clip-on fittings and adaptors to enable Marshall-Tufflex Mini-Trunking to be integrated within the system. With a base section specially designed to cater for imperfect walls to ceiling corners.

INSTALLATION

The base should be secured every 500mm by drilling oversize holes in the wall side of the trunking and fastened using round head screws with washers. Avoid over tightening to permit thermal movement. See Material Data page 200 for Thermal Properties.

click to enlarge

JOINTS

At each base joint 3mm should be left between each consecutive length of base for expansion and all bends must be mitred to ensure total enclosure of trunking. These mitres are not critical as the fitting covers the bend and overlaps the lid and simply clips on to the base.

ACCESSORIES

These are serviced through a spur using a mini trunking adaptor across the ceiling or down the wall to an appropriate box.

Reversible Adaptors

click to enlarge

LID

On completion of the base and cable installation, using cable retainers where necessary, install lid by pressing firmly into position ensuring adequate overlap at the fittings.

END CAPS

These come complete with clips offering security to the end of the trunking.

LID REMOVAL

Remove a suitable fitting and peel off cover.

DIMENSIONS AND CABLE CAPACITIES

click to enlarge
	A = 837mm2 total area 45% SF = 376mm2.

ANGLED CABLEWAY TECHNICAL INFORMATION

The Angled Cableway System is suitable for both horizontal and vertical corner mounting and features either a single or twin compartment trunking.

INSTALLATION

The base should be secured every 500mm by drilling oversize holes in the wall side of the trunking and fastened using round head screws with washers. Avoid over tightening to permit thermal movement. See Material Data page 200 for Thermal Properties.

click to enlarge

ACCESSORY BOXES

All accessory box entries are detailed with the divider in the top of the trunking in horizontal applications, to the left in vertical applications. The standard accessory boxes are installed between the trunking. The direct entry can be installed in any position along the trunking length by using any two in line fixing holes

DIMENSIONS AND CABLE CAPACITIES

click to enlarge
	A = 515mm2 total area 45% SF = 231.8mm2.
	B = 162mm2 total area 45% SF = 73mm2. C = 334mm2 total area 45% SF = 150mm2.